Your car battery is an essential part of your vehicle, and it’s important to keep it charged and ready. Even if you never use your car, you should still take care of the battery so that it lasts as long as possible. That article, will discuss how to properly maintain a 12v Lifepo4 Battery so that you can get the most out of yours:
You Should Clean The Lifepo4 Battery 12v Top, Terminals And Connectors
You should clean the Lifepo4 Battery 12v top, terminals and connectors to remove any dirt or corrosion. You should check the battery for leaks and corrosion. If there is any leaking, then you will need to replace it immediately because that could cause an explosion in your car. You should also check the battery for cracks or dents as well as bulges that could indicate swelling inside the casing of your LiFePO4 system. You don’t want to take any chances with that type of equipment so inspect it thoroughly before installing it into your vehicle!
Prime The 12v Lifepo4
Before you can charge your 12v Lifepo4, it needs to be primed. Priming can be done with a standard charger or even a car battery. To prime your 12-v Lifepo4 Battery:
- Set the charger to the correct voltage (14-16V) and connect it directly to your lead acid battery’s terminals. Do not use an extension cord or power strip when doing that because they may cause damage if there is any loose wiring inside them that could come in contact with each other while charging the lead acid battery; instead plug directly into an outlet so nothing else comes between them while they’re being charged together!
- Let it sit for at least six hours without turning on any lights or running any electronics during that time period so as not overheat themselves due to excessive current draw from using too much energy at once which could result in fire hazard if left unattended for long periods of time.
Then Turn On Your Charger And Wait For The Battery To Be Fully Charged
Then turn on your charger and wait for the battery to be fully charged.* Once it is, turn off your charger and unplug it.* Finally, you can now use your battery by plugging in whatever device it is intoOnce the six hours are up, turn on your lights and electronics. Do not use any power-intensive appliances until they’re fully charged, however! If you want to be extra safe with your 12-v Lifepo4 Battery and make it last longer then consider leaving a trickle charger hooked up to it overnight once every week or so if there are no special events planned for the next day or two.
If you are planning to use your battery for power tools or high-draw electronics then consider getting a bigger one, such as the Lifepo4 batteries from Redback. The Lifepo4 batteries from Redback are a great choice if you need something more powerful than the 12V OEM battery that came with your vehicle. They’re also safer than lead acid batteries and will last longer. If you want to know more about LiFePO4 batteries, speak to one of the technicians today!
Calibrate Your Lifepo4 12v Charger
- Calibrate your Lifepo4 12v charger once a month.
- To calibrate your battery charger, use the following procedure:
- Set the temperature range to 0-40 degrees Celsius or 32-104 degrees Fahrenheit and then set the voltage range to 14.4V-16V (or 21.2V). The higher end of that range is recommended if you have an older model that has been stored for some time without use as well as when first using it again after storage; however, if you have an newer model with more accurate measurements then use 16V instead of 21V for best results.*
- Once calibrated turn off all lights on your charger except for “charge” light which should be green in color.*
Use A Maintenance-Free Charging System
The best way to charge a battery is with a maintenance-free charging system. A good one will keep your 12-v Lifepo4 Battery charged and ready for use, as well as cool. That can be done by hooking up the battery charger directly to the car’s alternator or through an external source like solar panels or wind turbines. The most important thing when using that method is making sure that the voltage being put into it is correct: 14-16V (14V being optimal). If it gets too hot on its own, then it may cause damage over time which could lead to an early death for your precious battery!
Keep Your Battery Cool
- Keep your battery in a cool, dry place.
If you keep your 12-v Lifepo4 Battery in the trunk of your car or out in the hot sun, it will not last nearly as long as it would if it were kept in a cool location. The best way to do that is by storing the battery inside and away from direct sunlight (such as on top of some shelves). If that isn’t possible for whatever reason, make sure that there are no vents or other openings nearby where heat could enter and damage the battery.* Avoid storing with other items that produce heat such as tools or electronics.* Do not leave them near hot sources such as ovens/stoves/radiators/water heaters etc.
Connect The Battery To Your Charger
Connect the battery to your charger and set the timer for 15 minutes. Do not leave them in a car or other enclosed space when temperatures are high. Keep them away from children. Use a charger that is specifically designed for 12-V lifepo4 batteries. Using the wrong type of charger can damage the cells, reducing their capacity and lifespan. Check your battery’s voltage every few months to make sure it hasn’t dropped below 12V; if it has then recharge before using again.*
Using A Digital Charge
If you are using a digital charger, make sure that the voltage reading is between 14.4 and 16 volts and the amperage reading should be below 1 amp. If not then check all connections to make sure they are secure.* Set your battery charger to charge mode by pressing the button on your unit. The battery will slowly lose its charge over time, even if it is not being used. If you don’t use your battery for long periods of time, make sure to store it in a cool place (such as inside your house or garage). You can also drain the battery completely before storing it; that will help prevent sulfation, which can cause permanent damage if left untreated.* Do not store batteries near sources of heat including hot water tanks/stoves and ovens/etc.*
Properly Charging, Storing, And Maintaining Your 12-v Lifepo4 Battery Will Maximize Its Lifespan.
Properly charging, storing, and maintaining your 12-v Lifepo4 Battery will maximize its lifespan.
- Charge your 12-v Lifepo4 Battery once it’s fully drained. It’s important to only charge when it’s completely dead as overcharging can damage the cells and reduce their capacity over time.
- Store your 12-v Lifepo4 Battery at room temperature between 20°C-25°C (68°F – 77°F). If you’re going to be storing it for long periods of time make sure they’re fully charged before doing so; that will help preserve the overall health of your lifepo4 batteries by preventing them from losing any more energy than necessary while being stored away from use.*
If you want to keep your 12-v Lifepo4 Battery in good shape, it’s important to know how to properly care for it. We’ve covered a lot of ground here and hopefully given you some ideas on how to take care of your own vehicle’s power source. If there are any questions left unanswered or anything else missed please feel free to leave them a comment below!